【Voltage Compatibility】
When using electrical appliances, please note that they are designed for Japanese voltage specifications (90-110V), so if you use them with a different voltage, it may cause a malfunction.
【Plug Type】
Our products use Japanese plug types (A or B type).
Please use a conversion adapter if necessary.
【Important Note on Transformers and Adapters】
A transformer adjusts voltage to match your device’s requirements.
A conversion adapter only changes the plug shape and does not adjust voltage.
Using only a conversion adapter without a transformer may result in damage to the product.
【Liability】
We are not responsible for malfunctions or damages caused by improper use, such as operating the product without a transformer.
Roland genuine cutter holder Confirmed that it can be set correctly with the current model XD-CH3
This type has a thick cutting edge, so the surface of the blade is large, making it easy to cut thick sheets.
This is not a genuine product. 30° is the angle of the cutting edge.
This type is suitable for all PVC sheets. *Not suitable for cutting hard material sheets such as fluorescent sheets and reflective sheets.
We have received reports that the offset value is larger than the genuine product, and that it is not possible to set it to a value that allows for a clean cut with Steka.
Compatible with Roland's replacement blades for cutting plotters, this is a set of 5 blades with a 30° angle. This product has been confirmed to be made of extremely durable carbide material.
Roland Genuine Cutter Holder We have checked that all blades can be set correctly in the current model XD-CH3.
There have been reports that the blade cannot be set properly with old or deteriorated holders, so please consider this blade to be made specifically for the current model holder.
Compatible with Roland cutting machines, etc.
[Precautions when using with STIKA]
Although it can be used with STIKA, the offset value is larger than the genuine product, so it cannot be used for cutting fine letters of 1 cm or less.
It is not suitable for cuts such as right angles.
We have received reports that when cutting the rough shape of a curved design, although there may be some misalignment, it was possible to cut without any problems.
The thickness of the prop is a replacement blade with a diameter of 2.0 mm.
◇30°: Suitable for fine letters, but durability is low because the cutting edge is used intensively ◇45°: Suitable for moderate general use ◇60°: Suitable for straight lines, durable, but the cutting edge is obtuse, so it is not suitable for cutting small letters
We also sell a variety of cutter blades.
This product is not a genuine product, so self-control is required when using it.
The distance between the center of the blade and the tip of the blade is the offset value, which is approximately the radius of the shaft.
The cutting edge of the Roland type is on the inside, so make fine adjustments to 0.5-0.75-1.0, which is smaller than the radius value, and choose one that cuts the edge cleanly.
Since this is an imported product, there may be variations in the shape and length of the cutting edge.
Therefore, each time you set the blade in the holder, it is necessary to perform a test cut and adjust the offset value and blade length to ensure proper cutting.
Since this product is not under the control of the manufacturer, it is assumed that damage to the device itself caused by this product will not be covered by the manufacturer's warranty. Although the material and sharpness of this product are very good, we recommend this product to those who value cost performance and are aware of the errors and guarantees.
*Company names and product names mentioned in the description of our products are generally trademarks or registered trademarks of each company.
